I used my patented* (*not patented, but I’m pretty sure I invented this) built-up posts-a 3-ply assembly of 2×6-2×4-2×6-to create a strong, inexpensive and very stable post. To fasten the bottom block to the interior joist, I pre-drilled some pilot holes with my countersink bit and blew some 3-in. The reason my hands are outstretched in the photo is because the snowflakes that were falling were so big, they practically made noise when they hit the ground and they were extra beautiful.
#THROWING SHADE INSTALL#
A clamp makes it easier to install alone. These serve to “bottom out” the post when I install it. With the band straight, I fasten 2×10 blocks to the underside of the joist. If the lumber undulates at all, the reflective surface of composites can be noticeable (not an issue with wood decking). Thicknesses can vary, but this is only an issue when using composite decking. Crowning them is all but a waste of time, because they’re dead-on. Note: I know some contractors complain about using pressure-treated lumber, but what my lumberyard calls “#2 wet” is nearly arrow-straight. Once straight, I fasten the bridge boards to it, and it’s held fast. To make sure the band is straight, I run a string along the top corner from end to end and nudge the band as needed. I do this with what I call “bridge boards ” basically 4-foot scraps screwed to interior joists. The first step after that is to straighten the outside band joist-and keep it that way during assembly. The awesomeness of the shade structure starts after framing is completed. (Too deep on the Thor references here? I might consider getting some kind of social life…) Bridge Boards In the meantime, the road to Pergs-gard starts with the framed deck. So, in addition to the cedar posts, rails, rafters and cladding, the keystone that carries the arch (so to speak) are the fasteners, namely the structural screws and their placement in the frame and the finish. Nevertheless, the design needs to live in the world and across time. I don’t want to get too woo-woo on the design-y stuff, but there’s more than a little merit to it as I saw come to life in this project. They can be elements that create space and place. They can be dialed-in, detailed, designed. Your deck’s guard rails don’t have to just be guard rails.
#THROWING SHADE PRO#
On this episode of the DIY Pro Show we’re gonna turn this… Make a deck guard rail into a shade-throwing thing of DIY beauty.
Alternative Heating & Fireplace Inserts.
0 kommentar(er)
